SE1 – Sonos Era 100 Outlet Mount

Fits: Sonos Era 100

This mount holds the Sonos Era 100 securely and directly on the outlet. Plug and cable disappear completely inside – no drilling or gluing at all.

Product information

The set consists of 4 parts: Sonos Era 100 holder, Schuko adapter for the plug, cover for the underside and M5 screw for fixing the Sonos.

The Schuko adapter completely encloses the original Sonos plug and turns it into a Schuko plug with a solid hold. This way it carries the 2 kg as well as the pressure when using the touch controls. Thanks to the screw, the Era 100 is secured against falling. Adapter and holder are firmly connected and cannot come loose on their own.

Important: Make sure your outlet is firmly screwed to the flush-mounted box in the wall, as it has to carry the entire weight.
Do not heat above 50 °C, as this may cause permanent deformation!
The Schuko adapter fits all common type C (DE/AT) and type E (BE/FR) outlets in the EU.

Safety notice: Work on the outlet must always be carried out with the fuse switched off and only by a qualified electrician. Working on the electrical circuit (230 V) is life-threatening!

Scope of delivery: Holder, Schuko adapter, cover, M5 screw.
Sonos Era 100 and power cable are for presentation purposes only and are not included.

Size & weight

• 120 mm wide, 131 mm deep, 55 mm high
• approx. 165 g (mount incl. adapter, screw and cover)

Manufacturing

The mount is made using FDM 3D printing with a fine layer height of 0.16 mm. The fine “ridges” typical of 3D printing are present, but only visible up close.

Only branded PLA (polylactide) filament with a matte finish and slightly rubberised feel is used for printing.
Colours: White = RAL 9003 | Black = RAL 9017.

Each piece is 100 % handmade, so there may be minimal variations in appearance.

Further finishing

The mount can be finished further. As long as the plastic is not heated above 50 °C, you can:

• sand it (removes the fine ridges completely)
• prime it
• varnish / paint it