This mount hides the Apple power adapter (18 W/20 W), the entire HomePod mini cable and any standard single outlet completely inside. The HomePod mini is set in at an angle: the touch panel is tilted forward by 20°, making it easier to see and use. The HomePod mini also sits firmly in the mount this way. Thanks to a new design concept, it sits level and stable even without an outlet adapter.
Which version fits?
- Standard: completely hides a single outlet. Can also be used for the top outlet of vertical multi-outlet units (open at the bottom). Does not fit horizontal power strips.
- Power strip left: for the outer left outlet of a horizontal power strip.
- Power strip right: for the outer right outlet of a horizontal power strip.
Not sure? Feel free to send me a photo of your outlet and I’ll help you choose.
Product information
The HPM3 fits tightly around the power adapter, and the cavity stores the cable and the outlet. It covers standard outlets up to 85.3 × 85.3 mm, whether round or square – tested with deep and further protruding outlets. The power adapter is held at a slight angle to compensate for it sagging in the outlet, so the mount sits straight and flush against the wall. A Schuko adapter is no longer needed. As the mount is open at the bottom, there is sufficient air circulation.
Scope of delivery: the mount only.
HomePod mini and power adapter are for presentation purposes only and are not included.
Size & weight
- 90 mm wide, 87 mm high, 92 mm deep
- approx. 82 g
Product video
Manufacturing
The mount is made using FDM 3D printing with a fine layer height of 0.16 mm. The fine “ridges” typical of 3D printing are present, but only visible up close.
As the HPM3 is printed upside down (approx. 9 hours of printing time), a support structure is needed. The surface the HomePod mini rests on is therefore slightly rougher – but it is completely hidden after assembly. In return, the curves are very clean and without steps.
Only branded PLA (polylactide) filament with a matte finish and slightly rubberised feel is used for printing.
Colours: White = RAL 9003 | Black = RAL 9017.
Each piece is 100 % handmade, so there may be minimal variations in appearance.
Do not heat above 50 °C, as this may cause permanent deformation!
Further finishing
The mount can be finished further. As long as the plastic is not heated above 50 °C, you can:
- sand it (removes the fine ridges completely)
- prime it
- varnish / paint it
Reviews
There are no reviews yet.